Mounting your Kruzer Kaddy is easy as 1...2...3! Here you will find step by step mounting instructions with photos to guide you along.
Choose the location on the handlebar where you want your Kruzer Kaddy.
Be sure to choose a location high enough
on the bar to ensure adequate clearance between the bottom of the cup and tank.
To mount this bracket on 1 inch bars,
place the two thin clamp reducers inside the round of the top and bottom pieces of clamp.
To mount this bracket on 7/8 inch bars,
place the two thicker clamp reducers inside the round of the top and bottom pieces of clamp.
Using the supplied Allen wrench, attach the bracket onto the bar.
Attach the reversible mountings stud to upper handlebar clamp with the mounting stud bolt.
For rigid (non-swiveling) cup mounting, have the oval spacer facing toward bolt head and rider. The oval spacer should be perpendicular to the ground with the bike in an upright riding position. Tighten bolt with provided Allen wrench, once you have the cup straight when bike is upright.
For swivel mounting of cup holders, have round spacer facing toward the bolt head and driver.
Tighten bolt with provided Allen wrench.
The can / cup holder is mounted by putting the large diameter of the keyhole over the mounting stud bolt and sliding the cup down onto the bolt head.
The rubber grommet must then be inserted into the large diameter of the keyhole, thus locking the cup to the mounting bracket.